Barcelona BromptonSon hub dynamo - Loro's blog

2013年04月21日

Roller replacement - 2 / ローラーの代わりに - 2

I have made following pieces out of aluminum shaft, which should replace original rollers, based on prototype I made on the other day. / ローラーを置き換えるために、先日作った試作品をベースに、下記のようなパーツをアルミ棒から製作した

leg

3 pairs, different length, with original roller (46g / pair including the bolt)
長さの異なる3セットと、元のローラー(ボルト込み、2個で46g)



16g16g / pair (this pair is in the middle of above photo).
Other pairs are 17g or 15g.
Total wight would be 19 - 21g/pair including Titanium bolts.

2個で16g (このセットは上の写真で真ん中の2つだ)
残りのセットは、17g と 15g
チタンボルト込みの合計の重さは1セット19 - 21gとなる。
The reason why these parts are longer than height of original wheel is that I am planning to own new brompton without mudguard. I have noticed that original roller or easy wheel are too small concernig fitting front wheel into the right position when the bike is folded. Thus, this parts will lift the bike little higher so that front wheel fits well.

このパーツが元のホイールの高さより長いのは、新しいブロンプトンを泥よけなしで使おうと思っているためだ。
折りたたんだときにフロントホイールの収まりを適正な位置にすることを考えると、元のローラーやイージーホイールの高さでは低すぎることがわかっているので、このパーツによって、車体は少し持ち上がり、フロントホイールが適切な場所に収まるはずだ。

The protptype was made simple solid stick, on the other hand, above pieces are hollow shaft to reduce weight. Then rubber sponge was added on the tip of piece.
試作品は単純な棒状のものだったが、上記のものは中空にして軽量化している。また、ゴム製のスポンジを先端に取り付けた。

One day I will share some photo once my new brompton with this parts is ready.
このパーツをつけた新しいブロンプトンが完成したら、写真を共有する予定。


s2l_x at 18:26│Comments(0)

コメントする

名前
 
  絵文字
 
 
Barcelona BromptonSon hub dynamo - Loro's blog